Vape Ignition 763999900 available with DC lighting. Can only be used with ignition cover in place.
Designed for the twin cylinder, small displacement Honda includes everything shown in the picture. Magnet based generator with integrated solid state ignition. Output 12V/100W with DC regulator. This will make your 12 volt electrical system capable of handling LED lighting, but LED is not required.
The parts of our kit are not designed to operate in oil. It is therefore advisable that there is no oil or oil mist in the engine compartment where the rotor and stator are located. In the specific case of the CB models, the situation is not entirely critical due to the position of the stator on the engine cover and also due to the amount of oil and the location of the oil inlet, which is primarily intended to lubricate the starter drive mechanism. It is recommended to block off the oil inlet so there will be no further iissue with use of this ignition.
This replaces the complete old electrical system. Solid state, maintenance free, electronic ignition. There is no need for changes on engine casing. Can be used with or without battery for models using lighting coil. Electric start (if built-in) is no longer supported!
Fits models:
1960s era CB160, CL160, CL175 - this is compatible but may need slight modification
1971 CB175 | CL175 K3-K6 ONLY!
1974-1976 CB200 | CB200T | CL200
**this system was designed on the vertical 175 motors and may require modification on the crankcases to adapt to the earlier 160 and sloper 175 engines
Subsystem | |
Filter By: | complete ignition |